Some are suited for thinner plate, some for thicker. Some are fast, some are slow. Some are low-cost, some expensive. And some are accurate, some are not. Taking flame cutting as
an example, the flame is not intended to melt the metal, but to bring it to its ignition temperature allowing the metal to burn and blowing the resulting molten oxide through to the
other side producing the ideal kerf in a narrow gap with a sharp edge on either side of the work piece. The oxidation of iron by this method is highly exothermic. Once started, steel
can be cut at a surprising rate, far faster than if it was merely melted through.
The overlap of thickness range and capabilities of these four processes makes it hard to choose which one to use on any particular mild-steel part. So fabricators or steel service
centers who need the ability to cut a wide range of materials will often wind up with machines equipped with two or more cutting processes. Sometimes the only way to figure out
which process is optimal for a specific part is to try it several different ways, and see which one works best.
The ability to supply almost any shape from large steel plates gives SMC Steel flexibility in meeting our customer’s needs.